If it's printing smaller than expected, you probably need to crop away the area around the edges of the image that aren't part of the pattern. Go to...

Printers usually can't print to the edge of the page so I have to add a margin around each page. If you want your design to fill a page without gett...

There are a couple ways to make your lines thinner or thicker in your printout. If you drew your pattern in the Designer, you'll get the best result...

On the page where you enter the size, click on the % button. Rapid Resizer may not have correct information about the original physical size of your design,...

In the step where you enter the size you want, make sure Lines (in the Options near the bottom-left) is set to unchanged. Setting the Lines option to other ...

If Rapid Resizer makes your resizing but you get an error when you send it to your printer, try restarting your printer, computer or both.  If that does...

On the page where you enter the size, click on the Save Ink button under the Customize your design pull down.

By default, the printout is centered, but you can override that if you want to prevent part of a design from crossing a page edge or for another reason. ...

If the print preview looks fine but parts are missing when printed out: Check that Rapid Resizer's page margin option is 0.5". It's near the ...

On the webpage where you enter the size, you can click the Options button below to reveal more settings. There you can force the orientation to landscap...